418 plant & equipment hire suppliers · 15 machine classes · 56 locationsIndependent Australian hire directory

Machine type MC-03

Crane Hire in Australia

Franna/pick-and-carry, all-terrain, crawler and truck-mounted cranes, dry or wet hire with crew.

Crane Hire: machinery working on an Australian project
67Listed suppliers
8States covered
NSWMost suppliers
6Machine groups

Crane hire in Australia is almost always a wet hire. The crane comes with a licensed operator and often a dogman or rigger, working to a lift plan. The crane's advertised tonnage is its maximum capacity at minimum radius. Real capacity drops quickly as the radius, boom length and configuration change. Always request a crane using the load mass, pick and set radius, and site constraints rather than a tonnage figure.

01 · The fleetCommon crane options

MachineBest suited to
Pick-and-carry (Franna-type) cranesFast set-up, can travel with a load on suitable ground. Common on building and industrial sites.
Truck-mounted & city cranesRoad-registered units for short-duration urban lifts, deliveries and plant installs.
All-terrain (AT) cranesHigher capacity and reach. Outrigger loads and counterweight transport need planning.
Crawler cranesHeavy, long-duration lifts on prepared ground. Significant mobilisation and assembly.
Vehicle loading cranes (crane trucks)Delivering and placing materials, containers and plant in a single visit.
Mini/spider cranesGlazing, indoor lifts and tight access where larger cranes cannot set up.

02 · ApplicationsWhat it's hired for

  • Structural steel and precast erection
  • Plant and HVAC installation
  • Glazing and façade panels
  • Container and machinery movement
  • Bridge and civil works
  • Shutdown and maintenance lifts

03 · PricingWhat affects the hire rate

Hire rates for crane vary by supplier, location and season. A lower daily rate can cost more once transport, minimum hours and extras are added. Compare quotes on these drivers:

  • Crane class and configuration
  • Minimum call-out (often several hours)
  • Travel time to and from the depot
  • Counterweight transport and assembly
  • Crew size (dogman, riggers, traffic control)
  • Lift study or engineering requirements

See how to compare machinery hire quotes on equal terms.

Before you call

Send the load weight, dimensions, pick and set positions, and photos of the setup area. The supplier will then select the crane and confirm outrigger loads.

FAQCrane Hire FAQs

What size crane do I need?

It depends on the load mass, rigging mass and the radius from the crane's centre of rotation to where the load is picked and set. A 20 t crane may only lift a small fraction of that at long radius. Give the supplier those figures and let them size it from the load chart.

What is included in wet crane hire?

Usually the crane and a licensed operator. Dogman or rigger, travel time, permits, counterweight trucks, traffic control and lift planning may be extra. Confirm the minimum hours and how travel is charged.

Who is responsible for ground conditions under the crane?

Responsibility is usually shared and must be agreed. The site should identify underground services, voids and ground capacity. The crane provider calculates outrigger loads and specifies mats or pads.

Do I need a lift plan?

Most lifts need at least a documented lift plan, and complex or critical lifts need an engineered lift study. Your principal contractor and crane provider will set the requirement under the applicable WHS framework.

GuidesRelated selection guides

Supplier directory

Crane Hire suppliers by state

67 listed suppliers. Confirm the dispatch depot, fleet and service coverage for your site directly with each company.

Crane Hire: Australian Capital Territory (4)

Crane Hire: New South Wales (23)

+ 11 more in the full directory

Crane Hire: Northern Territory (6)

Crane Hire: Queensland (12)

Crane Hire: South Australia (9)

Crane Hire: Tasmania (1)

Crane Hire: Victoria (11)

Crane Hire: Western Australia (9)